 | |
 | |
 |
The STM series standard oil heaters are used to heat up the mould and maintain this temperature, although they can be used in other similar applications. High temperature oil from the mould is returned to the cooling tank and cooled by indirect cooling. It is then pressurised by the high-pressure pump, sent to the heating tank and finally to the mould with a constant temperature. With our optimised design, oil can reach a maximum of 200°C and the OMRON temperature controller can maintain an accuracy of ± 1°C. |
Features
- PID multi-stage temperature control system can maintain a mould temperature with accuracy of ± 1°C
- Multiple safety devices can automatically detect abnormal performance and indicate this via visible alarm.
- Reliable mains isolator to cut power supply in case of emergency.
- Germen made SPECK pump features high pressure and stable performance.
- High temperature heat transfer oil is stable up to 200°C, suitable for long and continuous operation.
- Attractive appearance, easy to access and maintain.
|
|
|
|
| |
 |
High temperature oil from the mould (D) is returned back to the cooling tank, and then sent to the heating tank by the pump (F) to be heated by the pipe heater (H), and then onto the mould.
In this process, any oil overheating activates the solenoid valve (E) to allow cooling water into the cooling tank (G) to reduce the oil temperature. If the oil reaches the upper limit of the temperature sensor, the machine will active the overheat alarm. If the floating ball (P) in the oil tank (l) falls below a safe level, the machine will activate the low level alarm by means of a microswitch (N). |
| Applications |
| Mainly used for heating up and maintaining a constant mould temperature, and in other fields that require a constant flow of hot oil. |
|
| |
 Technical Specifications |
| |
| Model Selection |
| Mould clamping force (T) |
Moulding capacity (Kg/hr) |
Pump flow (L/min) |
| Below 50 |
Below 6 |
30 |
| 50 ~ 100 |
6 ~ 12 |
| 100 ~ 200 |
12 ~ 25 |
|
|
| Mould clamping force (T) |
Moulding capacity (Kg/hr) |
Pump flow (L/min) |
| 200 ~ 300 |
25 ~ 40 |
40 |
| 300 ~ 650 |
40 ~ 80 |
60 |
| Above 650 |
Above 80 |
100 |
|
| We reserve the right to change specifications without prior notice. |
|
|
| |
|
|
